Why does your car stereo sound louder when you pull off the freeway and come to a stop? Road noise steals much of the listenable portion of your music. At 70 mph, a typical automotive noise level of 85 dB leaves you with only 20 dB of listenable music. Applying Dynamat creates a "sonic barrier" restoring 3, 6, even 12 dB of lost dynamic range. Gaining just 3 dB doubles your effective amplifier power. And that means you hear more music.
Dynamat Door Kits come in two levels of performance. The Original Door Kit offers the best value for the money. The Xtreme Door Kit controls vibration four times better than Dynamat Original and requires no heat for installation, which makes the Dynamat Xtreme Door Kits a great choice for do-it-yourselfers.
Stop Vibrating Sheet Metal and Road Noise!
High vehicle noise levels cause driver fatigue and irritation, and will affect the way music sounds out of speakers. When the vehicle is noisy, music and conversations can sound unclear and distorted. Dynamat Xtreme is the highest efficiency sound damping material available and the most effective product for stopping noise and vibration in your automobile. With Dynamat Xtreme installed, road noise becomes silent energy. The effect this has on your sound system is phenomenal. Your music sounds clearer, your bass is louder and tighter, and your stereo can sound twice as loud. Add a Dynamat brand thermoacoustic liner- such as Dynaliner or DynaPad to fight heat and low frequency hums from engines and exhaust systems – and you’ve got a ride with even more noise-blocking ability, and better sound.
Dynamat Xtreme is a thin, super sticky butyl rubber bonded to an aluminum alloy skin. It is formulated with Vector™ Chemistry, and makes Dynamat Xtreme the most effective sound control material available. Dynamat Xtreme is very simple to cut and install. The butyl rubber and heavy aluminum will stretch and contour better than any other product on the market without tearing. It will conform easily to all interior surfaces, and the sticky butyl rubber will adhere to a surface and stay in place without any special surface prep, and without leaving any odor or dripping material. Install it in your vehicle, and experience the Dynamat Difference.
Applying Dynamat to your car's trunk is absolutely the easiest way to reduce road noise and stop rattles coming from the trunk. Start by adding full coverage Dynamat Original or Dynamat Xtreme. For the best results, apply a Dynamat absorbing foam--Dynaliner or Extremeliner--next. In high heat areas (for example, over a hot exhaust pipe), use Dynamat Xtreme and Extremeliner.
Applying Dynamat to the roof of your car can be time consuming, but the results are worth the effort. To lessen noise and provide greater thermal insulation, apply Dynamat Xtreme. (Dynamat Original is not recommended for roofs.) For greater improvements, add TacMat. An average car roof requires approximately 12 square feet of material. SUVs and vans have larger roofs and require more material.
Dynamat Eliminates Speaker Panel Distortion! Distortion is the Enemy to Your Sound System
Even the best new speakers cause speaker panel distortion. Home audio speakers typically come in well crafted, heavy boxes to eliminate this distortion--a solution that is impossible (or at least impractical) in your car. For your car, Dynamat is the solution. Applying Dynamat to the car door surrounding your speakers eliminates speaker panel distortion by transforming the flimsy sheet metal into a solid non-resonant baffle. Dynamat improves mid-bass performance and stops vibration rattles and squeaks. Your stereo will sound its very best with Dynamat.
Dynamat Speaker Kits come in two levels of performance. The Original Speaker Kit offers the best value for the money. The Xtreme Speaker Kit controls vibration four times better than Dynamat Original and requires no heat for installation, which makes Xtreme Speaker Kits a great choice for do-it-yourselfers.